This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
Farmall A fuel
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
-
- 10+ Years
- Posts: 20
- Joined: Wed Oct 17, 2012 5:02 pm
- Zip Code: 94551
Farmall A fuel
On these old tractors is it ok to use unleaded gas or should one add a gas additive ?
-
- Team Cub
- Posts: 24272
- Joined: Tue Aug 07, 2007 3:39 pm
- Zip Code: 45030
- Tractors Owned: At This Time
40 Farmall Cubs (Round Hood)
2 Farmall Cub (Square Hood)
2 IH Cubs (Square Hood)
5 Lo-Boys (Round Hood)
2 Lo-Boys (Square Hood)
2 Farmall 404's
1 Farmall H
1 Ferguson 20
1 Cub Cadet 125
1 Kubota B-7100 - Circle of Safety: Y
- Location: OH, New Haven (Hamilton County)
Re: Farmall A fuel
Unleaded is fine.
There are two ways to get enough Cubs. One is to continue to accumulate more and more. The other is to desire less.
-
- 10+ Years
- Posts: 9
- Joined: Thu Aug 22, 2013 12:41 pm
- Zip Code: 37370
Re: Farmall A fuel
What about octane?
I read that it should be at least 90. That means $premium$ ?
I read that it should be at least 90. That means $premium$ ?
-
- Team Cub Mentor
- Posts: 6018
- Joined: Thu Jun 07, 2007 9:34 am
- Zip Code: 06040
- Tractors Owned: 77 Cub (red); 74 Cub; 52 Cub; 50 Cub ( post-demo)
- Circle of Safety: Y
- Location: CT, Manchester
Re: Farmall A fuel
I don't have a Super A but I would be shocked if a 6:1 compression ratio tractor engine needed premium.
-
- 10+ Years
- Posts: 987
- Joined: Fri Sep 20, 2013 11:17 am
- Zip Code: 01085
- eBay ID: havoc1482
- Tractors Owned: _______ 1948 Farmall Super A
- Circle of Safety: Y
- Twitter ID: @havoc1482
- Location: Westfield, MA
Re: Farmall A fuel
I just run regular unleaded gasoline in mine
Mike
I bleed Black & Gold
IH Collectors Club New England (Chapter 18)
Western Mass. (The 413)
I bleed Black & Gold
IH Collectors Club New England (Chapter 18)
Western Mass. (The 413)
-
- 10+ Years
- Posts: 5234
- Joined: Mon Jan 26, 2004 10:53 am
- Zip Code: 28521
- Tractors Owned: Collector of Super As, Corn Pickers, and a buncha other junk. Even a Cub now and then...
- Circle of Safety: Y
- Location: NC, Jacksonville area
Re: Farmall A fuel
Regular gas is fine.
Al
Al
White Demo Super A Restoration Updates
Let us pray for farmers and all who prepare the soil for planting, that the seeds they sow may lead to a bountiful harvest.
Celebrating 75 years of the Super A: 1947-2022
Let us pray for farmers and all who prepare the soil for planting, that the seeds they sow may lead to a bountiful harvest.
Celebrating 75 years of the Super A: 1947-2022
-
- Team Cub
- Posts: 17279
- Joined: Sun Feb 02, 2003 2:59 pm
- Zip Code: 55319
- Circle of Safety: Y
- Location: MN
Re: Farmall A fuel
382cr62 wrote:What about octane?
I read that it should be at least 90. That means $premium$ ?
There are at least 3 differnt measures of octane. Don't mix numbers off one scale with numbers from another.
-
- 10+ Years
- Posts: 227
- Joined: Sun Jan 20, 2013 10:36 pm
- Zip Code: 67357
- Tractors Owned: 1948 Cub, 1952 Cub, 1953 Cub, 1946 Farmall A, 1949 Farmall M, 1956 IH 130, 1979 IH 140, 1959 Farmall 240.
Several Brand X Green tractors that sound strange when they run.
1969 F-100 fully restored, 1969 F 100 original paint, 1973 F 100, 50 K original miles all original, 1978 F250 repainted, 1978 Bronco, 1967 Mustang, 1973 Mach ! Mustang.
Several single cylinder Honda motorcycles from the early 70's. Adding more junk all the time. - Location: Parsons, Kansas
Re: Farmall A fuel
I have worked on several engines that were victims of valve / valve seat damage from unleaded fuels. As most of us know the lack of lead can and does cause problems, but mostly in heavy load applications. 10 - 15 years ago I repaired several truck engines mostly big block fords (I'm a Ford guy so that is what I worked on) from the sixties and early seventies that the valves eroded into the seats and were in terrible condition. Most of these were construction or farm trucks pulling heavy trailers, etc.
Others are right about the octane; It will not be an issue on low compression tractor engines. Modern car engines run 2 or more full points higher compression ratio than our old tractors do, with no problems.
Others may not agree with me on this, but here is what I do on a couple of my tractors. I have a cub and a regular A that have belly mowers and see regular use with moderate to heavy loads. I go to my local air port and buy 10-15 gal. of aviation fuel at the beginning of the summer. I mix 2 gal with 5 gal of regular gas, and burn this mix in these two tractors. They really run good and it adds a little lead to the mix.
One other note: I run pure Aviation fuel in my weed eaters, chain saws, push mower, tiller, and my Honda generator. Some may say it is wrong, or a waste of money, but it works great. No more sour fuel after a sitting a month or 2, and there is no alcohol to cause issues with rubber lines and carburetor parts. Many of my small engines sit during the off season. I have had Aviation fuel sit in my generator for over a year and it is as fresh as the day I bought it.
Now the bad part. It was just under $6.00 per gal last spring when I bought it. Now before you say thats too much money think back 25 years, and remember how little trouble we had with carburetors, fuel lines and other rubber parts back when we had real fuel to burn. My time spent fixing fuel related problems on small engines has almost disappeared. This leaves me more time for rusty tractors.
Brad
Others are right about the octane; It will not be an issue on low compression tractor engines. Modern car engines run 2 or more full points higher compression ratio than our old tractors do, with no problems.
Others may not agree with me on this, but here is what I do on a couple of my tractors. I have a cub and a regular A that have belly mowers and see regular use with moderate to heavy loads. I go to my local air port and buy 10-15 gal. of aviation fuel at the beginning of the summer. I mix 2 gal with 5 gal of regular gas, and burn this mix in these two tractors. They really run good and it adds a little lead to the mix.
One other note: I run pure Aviation fuel in my weed eaters, chain saws, push mower, tiller, and my Honda generator. Some may say it is wrong, or a waste of money, but it works great. No more sour fuel after a sitting a month or 2, and there is no alcohol to cause issues with rubber lines and carburetor parts. Many of my small engines sit during the off season. I have had Aviation fuel sit in my generator for over a year and it is as fresh as the day I bought it.
Now the bad part. It was just under $6.00 per gal last spring when I bought it. Now before you say thats too much money think back 25 years, and remember how little trouble we had with carburetors, fuel lines and other rubber parts back when we had real fuel to burn. My time spent fixing fuel related problems on small engines has almost disappeared. This leaves me more time for rusty tractors.
Brad
-
- 10+ Years
- Posts: 4949
- Joined: Tue Jun 08, 2004 3:04 pm
- Zip Code: 14559
- Circle of Safety: Y
- Location: Rochester, NY
Re: Farmall A fuel
Fact of the matter is we will not use our tractors enough that lead or no lead will make a difference.
If your tractor goes down with a case of eroded valve seats, it was like that when you bought it. You didn't cause it. It took decades to get that way.
If your tractor goes down with a case of eroded valve seats, it was like that when you bought it. You didn't cause it. It took decades to get that way.
-
- 10+ Years
- Posts: 9
- Joined: Thu Aug 22, 2013 12:41 pm
- Zip Code: 37370
Re: Farmall A fuel
Now before you say thats too much money think back 25 years, and remember how little trouble we had with carburetors, fuel lines and other rubber parts back when we had real fuel to burn.
I can get "100% GAS" locally. Am I better off with it? It is about the same price as the 93 octane "premium".
-
- 10+ Years
- Posts: 5234
- Joined: Mon Jan 26, 2004 10:53 am
- Zip Code: 28521
- Tractors Owned: Collector of Super As, Corn Pickers, and a buncha other junk. Even a Cub now and then...
- Circle of Safety: Y
- Location: NC, Jacksonville area
Re: Farmall A fuel
382cr62 wrote:
I can get "100% GAS" locally. Am I better off with it? It is about the same price as the 93 octane "premium".
A lot of the same people that say to do something to add lead will say to use the 100% gas. IMO you are wasting your money. Most all our gas here now is 10% ethanol. All our small engines still start, and sometimes the gas sets all winter. The old tractors run fine. Maybe it's the climate, I don't know. But we haven't done one thing different since the advent of unleaded, or ethanol, and everything is ok.
Al
White Demo Super A Restoration Updates
Let us pray for farmers and all who prepare the soil for planting, that the seeds they sow may lead to a bountiful harvest.
Celebrating 75 years of the Super A: 1947-2022
Let us pray for farmers and all who prepare the soil for planting, that the seeds they sow may lead to a bountiful harvest.
Celebrating 75 years of the Super A: 1947-2022
-
- Cub Pro
- Posts: 10290
- Joined: Mon Oct 24, 2005 8:35 pm
- Zip Code: 23962
- eBay ID: dmb2613
- Circle of Safety: Y
- Location: VA. Randolph
Re: Farmall A fuel
I like the 100% gas and use it when I can. And the ethanol is horrible on small engines, I know this for a fact I work on them about every day it reeks havoc with the rubber parts, the primer bulb is the main problem, Stihl has improved the gas lines but the primer still gets soft . We have 100% gas at work, I know the boss would not pay the higher price for nothing.
The new mowers with gas engines seam to do fine.
The new mowers with gas engines seam to do fine.
IN GOD WE TRUST
All others pay cash
Boss Hog
Power corrupts; absolute power corrupts absolutely byJohn Emerich Edward Dalberg
All others pay cash
Boss Hog
Power corrupts; absolute power corrupts absolutely byJohn Emerich Edward Dalberg
-
- Similar Topics
- Replies
- Views
- Last post
-
- 1
- 159
-
by Jim Becker
Thu Apr 21, 2022 1:27 pm
-
- 2
- 217
-
by jdeere86
Sun Apr 24, 2022 8:42 pm
-
-
The fuel leak at sediment bowl problem
by AriesEd68 » Mon Jun 13, 2022 3:13 pm » in Farmall A, Super A, AV, 100, 130 & 140 - 0
- 130
-
by AriesEd68
Mon Jun 13, 2022 3:13 pm
-
-
-
Touch control temp gauge, and a fuel gauge?
by ShawnAgne » Tue Aug 03, 2021 4:31 pm » in Farmall A, Super A, AV, 100, 130 & 140 - 1
- 271
-
by Barn1018
Wed Aug 04, 2021 10:19 am
-
Return to “Farmall A, Super A, AV, 100, 130 & 140”
Who is online
Users browsing this forum: No registered users and 2 guests