This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
4 position light switch
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
- Jason_Coffey
- 10+ Years
- Posts: 171
- Joined: Wed Oct 02, 2013 9:04 am
- Zip Code: 74011
- Tractors Owned: -
1958 F Cub with Woods 42C
1962 LoBoy with FH & Mott Flail - Location: Broken Arrow, OK
4 position light switch
I bought a new 12v four position light switch for my conversion, but I can't tell which wires go where. Does anyone have a pin out for this type of switch?
- Barnyard
- Team Cub
- Posts: 24240
- Joined: Tue Aug 07, 2007 3:39 pm
- Zip Code: 45030
- Tractors Owned: At This Time
40 Farmall Cubs (Round Hood)
2 Farmall Cub (Square Hood)
2 IH Cubs (Square Hood)
5 Lo-Boys (Round Hood)
2 Lo-Boys (Square Hood)
2 Farmall 404's
1 Farmall H
1 Ferguson 20
1 Cub Cadet 125
1 Kubota B-7100 - Circle of Safety: Y
- Location: OH, New Haven (Hamilton County)
- Contact:
Re: 4 position light switch
Does it look like this?
There are two ways to get enough Cubs. One is to continue to accumulate more and more. The other is to desire less.
- Bus Driver
- 10+ Years
- Posts: 2917
- Joined: Sat Feb 11, 2006 5:26 pm
- Location: NC
Re: 4 position light switch
Those switches are not that specific for voltage. And the lights use fewer amperes at 12 volts than did the 6 volt lights. The dimming feature will work for 12 volts but the dimming effect will be less than it was for 6 volts.
Luck favors those who are prepared
- Jason_Coffey
- 10+ Years
- Posts: 171
- Joined: Wed Oct 02, 2013 9:04 am
- Zip Code: 74011
- Tractors Owned: -
1958 F Cub with Woods 42C
1962 LoBoy with FH & Mott Flail - Location: Broken Arrow, OK
Re: 4 position light switch
My switch looks like this:
-
- Team Cub
- Posts: 17241
- Joined: Sun Feb 02, 2003 2:59 pm
- Zip Code: 55319
- Circle of Safety: Y
- Location: MN
Re: 4 position light switch
The one I had that looked like that had each terminal marked in the insulating board on the back side. Look closely.