Throw out bearing

Tue Jan 20, 2004 1:42 pm

I have a new throw out bearing where the hole is 1 1/4" and the shaft is 15/16" since I don't have a parts manual can you tell me is their is a bushing that will make up the difference? Thanks..

Tue Jan 20, 2004 1:57 pm


That's normal. There is no bushing. The TOB is located by the yoke that carries it. Don't forget to put the zerk to the bottom so you can grease it. I just found one assembled upside down. I'm sure it was never greased. :cry: