Farmall Super A, AV, 1939 - 1954
Moderator: Team Cub
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
14 posts • Page 1 of 1
Wow! That's a lot of weld!!! I have mixed feelings on this one. From a pure safety aspect I'd say change it. But, it's obvious that the welds have been there a long time and unless they show any signs of failure they are no doubt very strong. If you plan to work the tractor I'd say change it. If it is going to be a toy only then it obviously has a story to tell and I'd tend to leave it like it is.
If you opt to leave it, inspect it often for signs of cracking.
If you can't fix it with a hammer, you've got an electrical problem.
My wife says I don't listen to her. - - - - - - - - Or something like that!
I don't plan on ever really working it. Just to ride around in and maybe pull a trailer sometime. I plan on putting the front and rear cultivators on it but never really plowing it.
I am really leaning on replacing that piece but just wasn't quite sure on it.
I agree with Big Dog on this one. It is a lot of weld, but being a ship welders son I can tell you I have seen some pretty welds that don't hold, and some that last forever. Some of that could even be cleaned up and painted over. If you don't plan on working that tractor hard then my opinion is leave it alone and inspect it often. But, all of our opinions aside it listen to your intuition. If it says replace it, then replace it. You will feel much better about it in the long run.
"Beauty through function and simplification."
The second picture shows what may well be a crack on the edge of the flange near the weld. Even with all the weld I would be leary of it holding uo, The crack could go in a different direction.
I would say split the tractor, and have the part magna fluxed. It will show if there are any cracks forming. If it is going to only be a parade tractor, I'd say it should be OK if no major cracks are forming. But even if it checks out OK, I'd locate a replacment and change it out at the first sign on problems.
"Tiger" 1974 International Cub
"Goliath" 1960 IH modified Cub LoBoy
"Littl' Smokey" 104 Cub Cadet
"Red Light" 1952 Farmall Cub with 151 disc plow
"Bananna Pie" 1964 International 2404 Industrial
Replace it Terry. If you're ever on a road cruise and it gives up......you'd be in a world of hurt. Shouldn't be too hard to find another one.
Terry, I have a good housing if you decide to replace it. It will be so cheap, you will think that you stole it!!!!
I think that settles that
'60 FH Lo-Boy
'57 FH Cub "Rusty"
'56 FH Cub
(2) '48 Cubs
'75 IH 140 w/1000 loader
C-3 mower, FH Woods 42F, 22 sickle (2), 54A blade, L-54 blade, 194 plow, FH L-38 disk, FH LB disk, 144 cultivators, FH platform carrier
Replace it for all the above reasons. However -- since Emmet has a history .. it would make sense to hang on to the casting.
My super A had some of the damage that you have (not as bad) I changed the tube for a lot of diffrent reasons.
Good judgment comes from experience, and experience comes from poor judgment.
1959 LO-Boy 1950 Super A
14 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest