My 23-A disc harrow didn't have the rear gang set when I bought it last year. So, with some help, I received the dimensions and fabricated the set.
Don't have a torch, so fired up the grill...
Then, got out my hammer, vise and welding gloves...
Added the bar stock (1/4" x 1-1/2")...
Waited about 5-10 minutes and put it in the vise. Hammered one way...
Then the other...
Dipped it in a bucket of water, dried it off, and downstairs to the shop for measuring, drilling and fitting...
All complete and assembled on the disc...
Still need to get the stabilizing bar on the rear set, but that'll have to wait 'til later.
Here are the dimensions for the gang bar and clevis set:
Hope this helps.
How to fix them and how to use them.
Moderator: Team Cub
1 post • Page 1 of 1
- Similar Topics
- Last post
184 engine is making loud knocking noise in the rear by the flywheel.
Barna » Tue May 07, 2019 10:47 pm » in Lo-Boy Series - 154, 184, 185
Mon May 20, 2019 12:24 pm
Tue Jan 02, 2018 7:55 pm
Sat Dec 16, 2017 6:27 pm
by Our Pass Thyme
Wed Oct 12, 2016 5:18 pm
Sat Jan 28, 2017 8:38 am
Who is online
Users browsing this forum: No registered users and 1 guest