184 pto quit

IH CUB LoBoy Series - 154, 184, 185 Forum -- Questions and answers to all of your LoBoy related issues.

Moderator: Team Cub

Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
glmassar
Posts: 6
Joined: Fri May 04, 2012 8:16 am
Zip Code: 45742

184 pto quit

Postby glmassar » Fri May 04, 2012 8:28 am

Recently while mowing my pto quit. I have had the problem that when mowing for a while and
I stall the mower I would have to let things cool down for about an hour before the pto would work again
but like I said it just quit on its own this time. I took the pto switch off and cleaned the terminals and checked the
fuse. Everything seems OK. I found a hit on this site "184 pto switch" and it seems to bee the same. Any additional
thoughts. If it could be a switch where can I get one?

User avatar
b52c130
5+ Years
5+ Years
Cub Star
Cub Star
Posts: 188
Joined: Wed Sep 03, 2008 4:35 pm
Zip Code: 07869
Location: Randolph, NJ

Re: 184 pto quit

Postby b52c130 » Sat May 05, 2012 5:43 pm

glmassar, the 184 PTO switch is #107372C1 which also subs to #725-3022 (the same switch, but used on many cub cadets of that era). The #725-3022 can be Googled and found in many places for about $20 plus shipping. I would clean and check all of the electrical connections; fuse, switch, connections at PTO, and grounds. Then I would replace the switch since it is relatively inexpensive and most likely subject 'contact wear' over the years.

However, the 'heating up' over an hours use and then quitting until it 'cools off' sounds most likely like the 'coil windings' in the electric magnetic part of the PTO clutch unit itself. If this is indeed the problem, then contact 'Hamilton Bob' for a used coil. They are a rather pricey item.

Good Luck, NJDale

outdoors4evr
5+ Years
5+ Years
501 Club
501 Club
Posts: 987
Joined: Tue Jul 22, 2008 12:44 pm
Zip Code: 48423
Tractors Owned: 184
Location: Davison, MI

Re: 184 pto quit

Postby outdoors4evr » Tue May 08, 2012 6:56 am

Do clean all of the connections before buying parts. Also, clean inside the fuse holder on the dash. It may have rusted inside.
184 w/ Creeper & 3-Point
IH 3160a Mower
IH Model 15 Tiller

User avatar
gitractorman
10+ Years
10+ Years
501 Club
501 Club
Posts: 2429
Joined: Mon Oct 24, 2005 11:35 am
Zip Code: 14072
eBay ID: toysforjake
Tractors Owned: Lots of Cub Cadets!
1951 Farmall Cub
1977 IH Cub
1966 IH Cub
1965 IH Lo Boy
1949 Farmall Cub
Several IH 154 Lo Boys
1979 IH 184 Lo Boy
Simplicity 4416 Sovereign
Simplicity Conquest
Simplicity Legacy 4x4 Diesel
Circle of Safety: Y
Location: Grand Island, NY

Re: 184 pto quit

Postby gitractorman » Wed May 09, 2012 8:09 am

Also, if the PTO clutch is out of adjustment, it will heat up too much and cut out. This is a common problem on Cub Cadets with electric PTO clutches. Unfortunately, on the 184, it's not real easy to get to.
Cub Cadets 682, 1811, 1864, Simplicity Legacy XL 4x4 Diesel with FEL, 60" mower, 50" Tiller

glmassar
Posts: 6
Joined: Fri May 04, 2012 8:16 am
Zip Code: 45742

Re: 184 pto quit

Postby glmassar » Fri May 18, 2012 9:17 am

Thanks all for your help. One additional question. What should be the voltage at the pto switch and at the connector that goes into the clutch down below the pto switch. This is where the shaft connects into. I have been getting readings anywhere from .15 up to .30

George

Phazer
5+ Years
5+ Years
Cub Star
Cub Star
Posts: 134
Joined: Tue Aug 03, 2010 11:34 am
Zip Code: 46975

Re: 184 pto quit

Postby Phazer » Fri May 18, 2012 1:10 pm

IIRC . . . what your doing/seeing is called a voltage drop test. In essence, if 14.8 volts is available at the battery, somewhere around 14.5-14.6 is going to the clutch, (that's good). The .1-.3 is being used up by the switch.


Return to “LoBoy Series - 154, 184, 185”

Who is online

Users browsing this forum: No registered users and 3 guests