Thu Mar 14, 2013 9:48 pm
How do I go about replicating the tapered hole that the steering arm lock bolt goes into? Thanks
Thu Mar 14, 2013 10:10 pm
Fri Mar 15, 2013 4:54 am
thomas , i do not know how a home shop would do that . maybe one of our cubbers with a machinist backround could think of a "home brewed" way to do it . coppersmythe.............................................
Fri Mar 15, 2013 9:11 am
I believe George Willer had made a tapered reamer for that, but all of that requires a pretty good machine shop both to make the reamer with the original taper, and then making the hole at the correct angle. Unless ou intend to do it on a regular basis it is cheaper to buy another spindle. Many of the people on the site will have them. If the bolt is broken off in yours, just insert a punch in the hole on the back side and tap it out.
Fri Mar 15, 2013 9:58 am
PO replaced the tapered bolt with a large set screw. I needed to replace the arm. Set screw broke off. Looks like he may have drilled and tapped the spindle. So it's shot unless I do what he did and I'm not doing that. So off to the wanted section I go
Fri Mar 15, 2013 11:16 am
I have a pair of spindles if you are interested. I can look them over this weekend to confirm their condition. There are photos somewhere but I am not at my computer. I can post them tonight...just let me know. Thanks!
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.