Cub vertical exhaust muffler

[T-Mo]

I bought my vertical muffler from Rural King for my '50 Cub.

https://www.ruralking.com/stanley-muffl ... uffler-ih1

Tmo do you have the front weights to match those rears? I know only of 1 full set of those

From what I've been told, the rear weights on my '50 are from a John Deere M. I do have the right Cub front weights now on this Cub, but still have those rear weights on it.

[Jim Becker]

Tmo do you have the front weights to match those rears? I know only of 1 full set of those

From what I've been told, the rear weights on my '50 are from a John Deere M. I do have the right Cub front weights now on this Cub, but still have those rear weights on it.

I didn't look close enough before I answered. They look like weights for a JD M. I thought they were a set of W&N weights.
viewtopic.php?t=50013

[jsfarmall]

Yeah at first I thought they were W&N weights too. A closer look I seen they weren't big enough around.

[Mrblanche]

To get back to the original subject, I checked online and no Tractor Supply stores in the area had the correct exhaust stack/muffler in stock. So, I bit the bullet and ordered it online, specifying for it to be delivered to the store in Hillsboro.

About 15 minutes later, I got an e-mail and text that my order was ready for pickup. I went in and picked it up today, and it was the correct item, etc. She said they had it on the shelf. I told her the computer was saying she was out. I've run into that problem before, but usually the opposite direction; the computer says they have it, when they don't.

[ShawnAgne]

I have a question what muffler fits the exhaust pipe for the 184 motor that has a larger manifold? I haven't been able to find or figure out which one would. I've bought my mufflers for the 300 from Rural King, same mfg as Tractor Supply just cheaper in my area.

[indy61]

I have a question what muffler fits the exhaust pipe for the 184 motor that has a larger manifold?

I think they have 1-1/4" threads. Easiest thing to do is use a 1-1/4 x 1 black pipe bushing and go with the standard Cub pipe and muffler.

If you already have 1-1/4 pipe I think a muffler with a 1-5/8" inlet ID will fit (someone correct me if I'm wrong). Maybe something like this.

https://www.tractorsupply.com/tsc/produ ... _vc=IOPDP1

[Gary Dotson]

If my memory is correct, you can use a muffler for an Allis Chalmer B.