This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
My first cub! Need help
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
-
- Posts: 6
- Joined: Wed Jul 06, 2022 6:35 pm
- Zip Code: 27249
My first cub! Need help
I have my first cub, I have several other Internationals, over all seems in pretty good shape, but I can’t get it to run right. I cleaned the carburetor and it will idle for a minute then die. Usually starts right back. Tried a new carburetor and it only runs a few seconds on full choke only. Great compression, hot spark, and good fuel flow through the fuel system and carburetor. Kinda stumped at what to do or look at next. The cub is 12volt with electronic ignition.
-
- Posts: 6
- Joined: Wed Jul 06, 2022 6:35 pm
- Zip Code: 27249
Re: My first cub! Need help
If I open the carburetor drain then replace the cub starts and runs good for 5 seconds or so then dies. If I leave the drain out I have good flow out of it, it’s like it’s air locked. I have tried it with the gas cap off and didn’t help
-
- Team Cub Mentor
- Posts: 17489
- Joined: Mon Feb 03, 2003 6:45 am
- Zip Code: 21550
- Tractors Owned: "1950 Something" Farmall Cub
1957 Farmall Cub w/FH
1977 International Cub w/FH
1978 International Cub
1948 Farmall Super A - Circle of Safety: Y
- Location: MD, Deep Creek Lake
Re: My first cub! Need help
Have you checked the float settings on either one or both of the carburetors?
-
- 501 Club
- Posts: 1853
- Joined: Wed Jan 20, 2021 8:21 pm
- Zip Code: 44410
- Tractors Owned: 1968 Cub Fast Hitch
LF-1 Platform Carrier
144 Cultivators
L-F194 Plow(s)
F38 Disk
L-F3 Spring Tooth Harrow
CS Bell No. 60 Grain Mill on a unmodified Fast Hitch Disk hitch prong
Home Made Fast Hitch Potato Plow
54A Blade
Couple 1948 Cubs
172 Runner Planter
53 Fertilizer
Cub-3 Field Cultivator
Cub-189 Two Way Plow
Cub-22 Sickle Bar Mower
Mechanical Transplanter with side mount barrel (needs a fast hitch adapter) :)
Misc Belly Mowers
Wish List
International 100 Fast Hitch Blade
Mott Fast Hitch Flail Mower
Wish Wish Wish List
Fast Hitch Rotary Hoe
4E hammer mill - Location: Ne Ohio
Re: My first cub! Need help
Please check out this topic.
A lot of stuff mentioned you can try and cross off your list!
http://farmallcub.com/phpBB2/viewtopic.php?f=1&t=113234&sid=8e89c8a76ef60bba7267b1d133346b9c
A lot of stuff mentioned you can try and cross off your list!
http://farmallcub.com/phpBB2/viewtopic.php?f=1&t=113234&sid=8e89c8a76ef60bba7267b1d133346b9c
Last edited by SamsFarm on Wed Jul 06, 2022 7:58 pm, edited 1 time in total.
1968 Cub Fast-Hitch
-
- Posts: 6
- Joined: Wed Jul 06, 2022 6:35 pm
- Zip Code: 27249
Re: My first cub! Need help
I was just sitting here thinking about that, I need to
-
- Posts: 6
- Joined: Wed Jul 06, 2022 6:35 pm
- Zip Code: 27249
Re: My first cub! Need help
Sam’s farm thank you for that post link. I’ll check the air hole and float tomorrow and see how that is
-
- Posts: 6
- Joined: Tue Jun 14, 2022 8:06 pm
- Zip Code: 73061
Re: My first cub! Need help
You said you put a new (As in brand new?) carb on it and it will run for a few seconds and then die?
I had this exact problem, and found that the new carb had an air passageway that had not been drilled: https://youtu.be/IQbLbuSlQfc
Checks yours and see. After drilling this passage out, I have not had a lick of trouble from this carb.
I had this exact problem, and found that the new carb had an air passageway that had not been drilled: https://youtu.be/IQbLbuSlQfc
Checks yours and see. After drilling this passage out, I have not had a lick of trouble from this carb.
-
- Team Cub Mentor
- Posts: 17489
- Joined: Mon Feb 03, 2003 6:45 am
- Zip Code: 21550
- Tractors Owned: "1950 Something" Farmall Cub
1957 Farmall Cub w/FH
1977 International Cub w/FH
1978 International Cub
1948 Farmall Super A - Circle of Safety: Y
- Location: MD, Deep Creek Lake
Re: My first cub! Need help
Undrilled air bleed hole...
-
- Team Cub Mentor
- Posts: 5643
- Joined: Thu Aug 03, 2006 6:20 am
- Zip Code: 43358
- Tractors Owned: 48 Cub Diesel (Cubota)
53 Cockshutt 20 restored (Shooter)
52 Cockshutt 20 unrestored
47 Leader "B" (Herckie)
49 Leader "D" (Princess)
49 Leader "D" very rough
48 Leader "D" unrestored
Kubota B6200E
Kubota B6200HST
Kubota B8200HST-D - Circle of Safety: Y
- Location: OH West Mansfield
Re: My first cub! Need help
The air bleed hole (bowl vent) would be my first guess. If the bowl can’t vent, it can’t fill with fuel.
Who is online
Users browsing this forum: Glen and 6 guests