This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
1 wire alternator wiring diagram
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
-
- Posts: 9
- Joined: Wed Dec 30, 2020 9:50 am
- Zip Code: 27009
Re: 1 wire alternator wiring diagram
the alternator is a SBC8162 121805E Chevy Danso. I did try exciting it by jumping from the post over to the tabs no charging. I am adding that resistor now as mentioned. Thanks
-
- Posts: 9
- Joined: Wed Dec 30, 2020 9:50 am
- Zip Code: 27009
Re: 1 wire alternator wiring diagram
should I put resistors on both wires going to the coil and the alternator?
-
- Team Cub Mentor
- Posts: 5616
- Joined: Thu Aug 03, 2006 6:20 am
- Zip Code: 43358
- Tractors Owned: 48 Cub Diesel (Cubota)
53 Cockshutt 20 restored (Shooter)
52 Cockshutt 20 unrestored
47 Leader "B" (Herckie)
49 Leader "D" (Princess)
49 Leader "D" very rough
48 Leader "D" unrestored
Kubota B6200E
Kubota B6200HST
Kubota B8200HST-D - Circle of Safety: Y
- Location: OH West Mansfield
Re: 1 wire alternator wiring diagram
No, only from the Bat. side of the coil to the vertical pin on your Mini Denso. Are you using a resister rather than a diode? That's fine but you need to select a resister with the appropriate value. You need enough current flow to excite the alternator but not enough to back feed the coil and prevent engine shut down. Measure the value through a dash light bulb and mimic that.
Dale, we might be able to come up with something.
Dale, we might be able to come up with something.
-
- Posts: 9
- Joined: Wed Dec 30, 2020 9:50 am
- Zip Code: 27009
Re: 1 wire alternator wiring diagram
OK I messed up I put the resistor in the coil line not he alternator by mistake. Tractor shut down. I have no fire. I have taken out the resistor, added new coil,condenser and points. I still have no fire. I just replaced all the wires plugs etch it was running good, Sorry to be a bother I'm lost. Mark..
-
- Posts: 9
- Joined: Wed Dec 30, 2020 9:50 am
- Zip Code: 27009
Re: 1 wire alternator wiring diagram
Still no luck added diode no charge.
-
- 10+ Years
- Posts: 8
- Joined: Thu Feb 16, 2012 12:10 am
- Zip Code: 15601
- Tractors Owned: 48 cub
Re: 1 wire alternator wiring diagram
Also having difficulties with my 12 volt conversion on my Cub. Installed a Chevy Mini Alternator 1 Wire 4 12180 SE. Wired alternator to battery via starter switch. Alternator is not charging. Do I need to excite it? Beside the battery terminal there also two spade terminals on the back of the alternartor. These are not labeled. There is a vertical one closest to the battery terminal and a horizional one to the left of the vertical one. Which terminals do I connect to excite alternator? Can I just flash it or do I need to install permanent wire with a diodoe? Thanks in advance for your assistance.
-
- Team Cub
- Posts: 17240
- Joined: Sun Feb 02, 2003 2:59 pm
- Zip Code: 55319
- Circle of Safety: Y
- Location: MN
Re: 1 wire alternator wiring diagram
This is a new question added to a fairly old thread. It should be, and already is, in a new thread. I am locking this one so any replies will need to be made in the other thread.
Who is online
Users browsing this forum: No registered users and 31 guests