Using Bob McCarty's Carb Gasket Template

[Dale Finch]

The following series of photos shows the steps for using Bob McCarty's Carburetor Template to make new body gaskets for your carburetor. You can find the posting for them at:
http://www.farmallcub.com/phpBB2/viewtopic.php?f=28&t=64485

1. Outline the template onto 1/16th" gasket material with pen or fine felt tip:


2. Punch holes -
1/8" for idle tube and crescent ends
3/16" for bolt holes and float corners
5/16" for curve at edge of float hole
1 1/16" for venturi hole (or cut with knife)


3. Cut crescent using template and cut float bowl sides with template or straightedge using the knife knife (utility or X-acto):


4. Cut outside with knife and template or scissors. (NOTE: cut away drawn pen lines or gasket will be wider than wanted):


5. Tools used:


MANY THANKS to Bob for all his hard work!!