Farmall A outter brake pedal

[Tb20]

Hey folks anyone removed the outter brake pedal on an A? I have the assembly off and on the bench I’ve got the tapered bolt out and I’ve had it soaking for a week I’ve tried heat but it will not budge. Are these pressed on?

[Slim140]

What are you heating it with, a cutting torch or a small propane bottle for soldering?

[Tb20]

Oxy-act with a rose bud

[Super A]

Last time I took one apart, I put it in a vice and hit the end of the shaft with a big punch and bigger hammer.....

Al

[Tb20]

Last time I took one apart, I put it in a vice and hit the end of the shaft with a big punch and bigger hammer.....

Al

Yea I have tried that also. I guess my next step will be to use the demo hammer as a punch. I just don’t want to break the casting on the brake lever

[Stanton]

Believe mine was mushroomed somewhat, which prevented easy removal. You might check that.

[SONNY]

Try moving it the other way just to crack the rust and allow fluid to enter. ---sometimes this works with heat, and once it starts moving you can work it back and forth. My sa was wrecked and outer peddle is broke off ---only the stub hangin on the shaft.

[Tb20]

Try moving it the other way just to crack the rust and allow fluid to enter. ---sometimes this works with heat, and once it starts moving you can work it back and forth. My sa was wrecked and outer peddle is broke off ---only the stub hangin on the shaft.

I will try that this weekend and see how it goes.

[EZ]

I have pushed one out on a hydraulic press. Fast and easy.