Mounting Runner Planter

[kapntx]

I mounted the Runner Planter that I got with a Super A to the tractor. The longitudinal axis of the planter does not lie parallel to the tractor. I have determined that the lift arm ends are not perpendicular to the tractor, as if one lift arm is too long to be a match with the other. When measured from the final drive housing the left lift bracket where the tool bar bolts on it is about 1-1/8” farther away than the right hand side one. Is there any way to adjust this or do I need a different lift arm?

[Jim Becker]

I assume by "lift arms" you are referring to some part(s) of the universal mounting frames. Could you post a picture of each side, preferably with a yard stick or the like in place to show the difference?

[kapntx]

With the planter aligned with tractor (eyeballed) the tool bar is this far off from bolting up to the lift bracket.

[Jim Becker]

OK, good. Now back up about 2 paces and take another picture that shows the entire universal mounting frame. Then take one just like it of the other side.