Power angle on F100/A60 blade suggestions

Farmall Super A, AV, 100, 130, & 140 1939 - 1973
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
User avatar
ShawnAgne
5+ Years
5+ Years
Posts: 825
Joined: Sat May 07, 2016 5:13 pm
Zip Code: 45380
Tractors Owned: 1952 Cub w/ 184 motor (Kid)
12V with Petronix
IH 3160 Mower Deck
54 Leveling Blade
193 Plow
IH528 Trailer
Front/Rear Weights
1955 Farmall 300 (Clarence)
12V with Petronix
Woods L306 72"
1955 Farmall 100 (Thomas)
12V with Petronix
Woods L59 60"
A60 Leveling Blade
Front/Rear Weights
Circle of Safety: Y
Location: Versailles, Ohio

Power angle on F100/A60 blade suggestions

Postby ShawnAgne » Wed Aug 04, 2021 5:11 pm

Ok found an A60 blade and was wanting to do a power angle like I have with my Cub/54 blade, which as been VERY nice. However noticed the bypass block will be on the right side and its all a little tight. Figure I could run the hydraulic lines off the left side and go under the frame. Looks like behind the gear shift would be the best place to mount the valve but the lines going to and from the bypass block may be a little tight. Just looking to see what anyone else has done before I reinvent the wheel.

Thanks in advance.
Shawn Agne
Top
  • Similar Topics
    Replies
    Views
    Last post

Return to “Farmall A, Super A, AV, 100, 130 & 140”

Who is online

Users browsing this forum: No registered users and 0 guests