Farmall 100 Restoration Update 11/13/21
Posted: Sun Nov 14, 2021 9:44 am
Well finally got the valve plumbed in for the power angel. Originally was going to place it behind the gear shift. However the bends on the tubbing etc. were going to be very complex. So decided to locate it as seen here.
From the valve I will run some hose out to the quick connectors and mount them on a plate on the large flat by the cutch bell.
Going to mount the control lever on the side of the dash (using the two punch out holes). This will put the control lever around the cuck and the touch control arms.
Need to pull it all off and paint it but it is slowly coming together.
Not pictured are the brackets on the A60 frame for the cylinder.
From the valve I will run some hose out to the quick connectors and mount them on a plate on the large flat by the cutch bell.
Going to mount the control lever on the side of the dash (using the two punch out holes). This will put the control lever around the cuck and the touch control arms.
Need to pull it all off and paint it but it is slowly coming together.
Not pictured are the brackets on the A60 frame for the cylinder.