Zenith Carb Kit

[customcutter]

I pulled the gas tank off my Super A and took it too a radiator shop to have it cleaned and lined due to the amount of rust in it. I decided to pull the fuel line going into the carb and a PO had cut the wire mesh filter off of it. So then I figured I should at least pull the carb and look inside it. Not good. The gasket had several previous tears in it, and the bottom of the bowl was rusty as well.

All I can find on the carb is "Made in the USA" and "Zenith B 24". The metal washer on top has so many layers of paint, I can't make out any numbers. I've done several internet searches and nothing comes up on Zenith B 24. Does anyone know which kit or part number for the kit?

[Don McCombs]

Give Morgan a call at McDonald Carb & Ignition. http://Www.mcdonaldcarb.com

[customcutter]

Thanks. I finally got some dental picks and a brass brush and cleaned off the brass washer. Numbers were 375560R91 and 12613A. Almost no information came back on those number searches on Zenith carbs either.

[Jim Becker]

That "R" part number is a Zenith 161x7, specific listing for the Farmall 100. 12613A is probably the Zenish number for the exact configuration. It was probably listed as a replacement for the Super A.