do I need these please help ASAP

[cjpenny89]

I just rebuilt the clutch on a 104 made a new driveshaft. when I put this back together do I need the 3 springs that are called anti-chatter springs?
everytime I see a clutch apart the springs are gone. do I need these when I put it back together?

I am also correct that the throw out bearing just rides and slides on the driveshaft and is not a pres fit?
thanks
Chad

[Dave Hull]

You are correct on the throw out bearing.

The anti chatter springs cut down on the pinging noise, especially as the holes in the clutch disk enlarge with wear. I always try and install at least one.

My 2 cents
Dave H

[Jack fowler]

cjpenny89

This is a site that John *.?-!.* cub owner posted at one time. I have two Cadets that are used all the time. One of them is a 1200 with continue clutch problems cause by broken engine mounts. I e-mailed Brian Miller and discussed the problem and he has come up with a cure for $74.00 including shipping. That’s a whole lot less than $160.00 every time my clutch blows apart

Clutch site http://members.aol.com/pullingtractor/clutch.htm

Brian’s web site http://members.aol.com/pullingtractor/tips.htm

PS. My thanks to this forum and to the people who have helped me on issues (like the one above) on my Cadets and Cubs.

Jack Fowler

[cjpenny89]

thanks for the help!
I found brians site a while back and I am about to try out his steel spacer and lock washer combo instead of the teaser spring. I will post back after I get it all back together.
Chad