This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
154 driveshaft length
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
-
- 5+ Years
- Posts: 33
- Joined: Fri Feb 01, 2019 7:19 am
- Zip Code: 16201
- Tractors Owned: International 184
154 driveshaft length
I see that Hamilton Bob lists 2 lengths of driveshafts for a 154 without a creeper, a 29" shaft and a 31" shaft. How do you know which one you need? I am removing the creeper from a 154 and would like to know if the spare driveshaft that I have will swap in.
-
- 10+ Years
- Posts: 2791
- Joined: Tue Jul 22, 2008 12:44 pm
- Zip Code: 48370
- Tractors Owned: 184
- Location: Oxford, MI
Re: 154 driveshaft length
I'm not certain, but the parts manual seems to have a lot of differences listed between the lower and higher serial number tractors. The breakpoint is serial 21491 and below or 21492 and above. Since the listing of part numbers do not describe the length, the best thing you can do is pull the existing driveshaft out and measure it.
Here's a crazy idea.... Call HamiltonBobsCubs and ask them. I doubt anyone has more experience parting out these numbered loboy tractors than they.
Here's a crazy idea.... Call HamiltonBobsCubs and ask them. I doubt anyone has more experience parting out these numbered loboy tractors than they.
184 w/ Creeper & 3-Point
IH 3160a Mower
IH Model 15 Tiller
IH-54 Blade
IH 3160a Mower
IH Model 15 Tiller
IH-54 Blade
-
- 10+ Years
- Posts: 7388
- Joined: Sat Jul 22, 2006 5:02 pm
- Zip Code: 00000
- Location: in northern usa
Re: 154 driveshaft length
It depends on where the pto pulley is. If it’s on the drive shaft it’s the longer one, if the pto pulley is on the engine flywheel its the shorter one.
I'm technically misunderstood at times i guess its been this way my whole life so why should it change now.
-
- 5+ Years
- Posts: 33
- Joined: Fri Feb 01, 2019 7:19 am
- Zip Code: 16201
- Tractors Owned: International 184
Re: 154 driveshaft length
BigBill wrote:It depends on where the pto pulley is. If it’s on the drive shaft it’s the longer one, if the pto pulley is on the engine flywheel its the shorter one.
That makes sense. Both of the 154s have the pulley on the flywheel so I should be good to swap. Thanks!
Return to “Lo-Boy Series - 154, 184, 185”
Who is online
Users browsing this forum: No registered users and 12 guests