Back cultivator help

[Kalebtrojacek]

Hey gentlemen I just put the back feet on my cub for the first time and the back feet at way too close to the tire. I couldn't get the cuff in to put a cultivator on like this. They also don't even make it to the center of the tire. Any suggestions?

[Ky Cub]

What holes on the final drives are you using, should be using the back holes that the drawbar mounts into. Other wise, you might have incorrect rear frames. Pictures might help.

[tmays]

Agree with ky cub, pics would better help us help you.

[Kalebtrojacek]

Here are a couple of pictures.

[Dale Finch]

I'm certainly no cultivator expert, but I believe you are using the wrong 2 holes for mounting...try the 2 REAR holes, one on top of the other, which would rotate the bracket 90 degrees.

http://www.tmtractor.com/tm-tractor/gim/rear_gang_001.htm

Actually, in comparing your photo and the TM photo, you may just have the two brackets swapped left to right finals...on the wrong sides. It's really hard to see your bracket's orientation well.

[Don McCombs]

Looks to me like you have the bracket on backwards. The clamp bolt end of the bracket goes out, not in. Check out the Cub-144 manual in the PDF Manuals section.

[Kalebtrojacek]

Thank y’all!

[tractorpoor]

Here are a couple pics of my setup. Hopefully it helps.

[tmays]

Tractorpoor’s pics are the way it should be

[Kalebtrojacek]

Thank y’all! Got them all set up now.