Rear hydraulic case leak

[johnthomas]

Could the kind individual or anyone resend the info for my 1951 cub rear hydraulic case leak,the box that holds the fluid. I need to take it off and rebuild.. It works but leaks. Thank you.

[Urbish]

That unit is known as the Touch Control block. You can search this site for lots of info using the search box in the upper right corner. You can also go to the "How To" section of the forum as there are several guides in there. Here is a link to the "How To" section: http://farmallcub.com/phpBB2/viewforum.php?f=141

[johnthomas]

Thank you..

[tst]

it may not need a rebuild, many times it is just the control shaft oring that has gone bad, that can be replaced without tearing it apart

[Glen]

Hi,
I found the post I think you meant. It was from late July.

viewtopic.php?f=1&t=104952

You can search through your posts at Quick links, at the upper left of the page.

[johnthomas]

Thanks, that's it. I am almost positive it's that bottom control rubber seal.I dont think looking at it that it can be repaired with out taking it off the tractor. Thank you again,
John

[tst]

you will have to remove it from the tractor but it can be replaced easily from the outside so you do not have to disassemble the unit

[johnthomas]

Thanks,now that makes sense and is good news.
John