Sat Jun 26, 2004 4:17 pm

Jim:

That would be a good idea. Eastern seaboard, Maine and into Ct, Md etc., might be doable. I think Chuck is in Michigan and that may be too far out of the way. If we do go stateside, we will probably head toward Texas, Arizona and California. Been too long since I have been to SoCal. Lots of good folks to visit on the way to and fro :D

Sun Jun 27, 2004 8:52 am

Dan, Thanks for the comments, I appreciated that. I just need to be more diligent before I comment. Sometimes my enthusiasm from the questions and possible responses gets me into the proverbial corner. Bob

Sun Jun 27, 2004 9:19 am

HR, I have two '52 cubs with belly mowers. One mower is an IH C-2 and looks like your's except for the skids and skirts. The other mower I have is a Woods.
The IH seems to do a better job of mowing. Both mowers cut like a good finish mower.
AL
I need a cover for the rear pulley drive. I don't think there was one made for it and I'm thinking about adapting a woods shield for it.

Sun Jun 27, 2004 11:41 am

Alden:

If you do, could you make a measured sketch for the plans and sketches section?

Thanks

Sun Jun 27, 2004 12:31 pm

I have a pulley cover for my C2 but you cannot use it with the rockshaft on the rear. Are rear lift arm?? What ever it is called.

Mon Jun 28, 2004 3:06 pm

Hummm..........my mower looks like that too.

http://community.webshots.com/photo/155 ... 5278nwgnRf


TBAR

Mon Jun 28, 2004 4:52 pm

Yep that's it alright and it looks like someone has made a adjustable rear right side shield. I have the rear factory shield for the rear but its rusted pretty bad but good enough to use for a pattern for a new one. If I ever get time to do something for myself. It goes alway across like the front one.