Hi guys,
I am attempting a cleaning/inspect/seal replacement on the touch control of my '67 Loboy. I have the outside all cleaned up, got the head off, the bottom off etc....It looks to me like I will have 13 seal rings to swap out. Problem right now is, I am concerned about breaking the connecting rod in an effort to remove the 3/4" yoke nut which is torqued down to 75lbs. Does anyone have a safe method of getting that nut off?
Also the yoke pin has quite abit of side slop, how much is acceptable?
I am using a good manual that describes the T.C. unit job, but some things it just does not tell you. One I get all my pistons, valves etc.. out I plan to wash the whole block in a good bath of..........varsol?
This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
Hydraulic Rebuild
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
-
- 10+ Years
- Posts: 1185
- Joined: Tue Feb 11, 2003 6:33 pm
- Zip Code: P0M1Z0
- Tractors Owned: 49 Cub
67 International Cub Loboy
57 Farmall 130 - Location: Northern Ontario
Hydraulic Rebuild
Just Do It !
-
- Similar Topics
- Replies
- Views
- Last post
-
- 2
- 209
-
by Magnum
Thu May 27, 2021 9:24 pm
-
- 2
- 174
-
by Glen
Sun Sep 04, 2022 5:18 pm
-
- 6
- 431
-
by ricky racer
Thu Dec 07, 2023 7:38 pm
-
- 5
- 624
-
by inairam
Thu Aug 24, 2023 6:07 am
-
- 3
- 257
-
by Glen
Sun Sep 19, 2021 8:00 pm
Who is online
Users browsing this forum: No registered users and 2 guests