The following series of photos shows the steps for using Bob McCarty's Carburetor Template to make new body gaskets for your carburetor. You can find the posting for them at:
http://www.farmallcub.com/phpBB2/viewtopic.php?f=28&t=64485
1. Outline the template onto 1/16th" gasket material with pen or fine felt tip:
2. Punch holes -
1/8" for idle tube and crescent ends
3/16" for bolt holes and float corners
5/16" for curve at edge of float hole
1 1/16" for venturi hole (or cut with knife)
3. Cut crescent using template and cut float bowl sides with template or straightedge using the knife knife (utility or X-acto):
4. Cut outside with knife and template or scissors. (NOTE: cut away drawn pen lines or gasket will be wider than wanted):
5. Tools used:
MANY THANKS to Bob for all his hard work!!
This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
Using Bob McCarty's Carb Gasket Template
-
- 10+ Years
- Posts: 6684
- Joined: Tue Apr 27, 2010 11:34 am
- Zip Code: 27517
- Tractors Owned: '51 Cub #140966 "Bruno" with Woods 59 mower
'55 Cub #187541 "Betty" with Fast Hitch
'55 Cub #190482 "Ben" with Woods 42 mower
'55 Cub #191739 "Bertha" with Woods 42 mower
'56 Cub #194370 "Boris" with Mott Flail mower - Circle of Safety: Y
- Location: NC, Chapel Hill
Using Bob McCarty's Carb Gasket Template
Last edited by Dale Finch on Sun Oct 02, 2011 7:06 pm, edited 1 time in total.
-
- Similar Topics
- Replies
- Views
- Last post
-
- 1
- 130
-
by Gary Dotson
Mon Jun 27, 2022 8:03 am
-
- 6
- 269
-
by bullmack
Sat Mar 05, 2022 9:30 am
-
-
Identification of my Engine and Carb - in order to get a new Carb
by JKaechler » Tue Dec 07, 2021 9:25 pm » in Farmall Cub - 14
- 627
-
by Don McCombs
Thu Dec 09, 2021 11:42 am
-
-
- 12
- 408
-
by goxu1
Tue Jul 11, 2023 5:36 am
-
- 7
- 465
-
by Clemsonfor
Mon Sep 13, 2021 4:57 pm
Who is online
Users browsing this forum: No registered users and 0 guests