assuming the necessary steps have been taken to remove the crankshaft pulley we will begin with the seal in the front engine cover.
Removing the seal can be done many different ways.................
if you have a seal puller they work verry well
it can be removed by using a small chisel to dent the sise in and pry it out with a screw driver
or you can make a seal puller by putting a sharp 90 degree bend on the end of a small peice of steel stock to pull it out.
if you have the front cover removed just knock it out fron the inside
clean the opening lube the opening for the new seal set the seal in place and tap it it in evenly
most of the crank pulleys have a worn groove in them where the old seal was riding so when ordering the seal get the one with the sleeve.
here the sleeve is set in place to be installed
and here we have a Master press operator applying the correct amount of pressure to push the sleeve on with out damaging it.
here we have the new wear sleeve installed and ready for installing the pulley back on the engine
The sleeve installation tool is another one of the excellant products of Bill poore and his friend EArl the Machinist.
This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
Replacement front crank seal
-
- Cub Pro
- Posts: 2673
- Joined: Sun Feb 02, 2003 7:01 pm
- Zip Code: 41005
- Tractors Owned: Near 200 cubs through the years
- Circle of Safety: Y
- Location: Ky Florence Y'ALL
Replacement front crank seal
Shoot low Sherriff they are Riding Shadows
4 Wheels move the body.....
2 Wheels move the Soul .....
Ralph in ky.
4 Wheels move the body.....
2 Wheels move the Soul .....
Ralph in ky.
-
- Similar Topics
- Replies
- Views
- Last post
-
- 4
- 210
-
by IHCFan1950
Sat Jul 31, 2021 10:28 pm
-
-
Broken crank update, and Rear Main seal / retainer question
by 69ranger » Wed Dec 08, 2021 11:42 am » in Farmall Cub - 6
- 403
-
by BigBill
Sat Dec 11, 2021 9:01 pm
-
-
-
Knob on Front for Hand Crank is Wicked Stuck
by FarmallCubGal » Sun Dec 17, 2023 4:23 pm » in Farmall H, HV, Super H, 300 & 350 - 6
- 2386
-
by FarmallCubGal
Sat Dec 23, 2023 8:54 am
-
-
- 2
- 178
-
by tst
Mon Jun 28, 2021 9:16 am
-
-
Newbie - Front Oil Seal - Opinions PLease Attachment(s)
by ktinsley12091960 » Sat Feb 17, 2024 5:50 pm » in Farmall Cub - 12
- 444
-
by inairam
Fri Feb 23, 2024 7:22 am
-
Return to “Engine, Clutch, Transmission and Hydraulics”
Who is online
Users browsing this forum: No registered users and 0 guests