Use a 1-1/2" PVC coupler fitting as shown:
Saw the coupler fitting lengthwise in 2 places removing a section approximately 1/4 to 2/3rds of the total circumference. This will reveal a molded step in the ID (which I marked in black for clarity) as shown:
Then saw the coupler fitting's overall length to approximately 1-1/2" - 1-3/4" as shown:
Slide the short end of the coupler fitting over the wear sleeve until the step hits the edge of the wear sleeve as shown:
Tighten a hose clamp around the modified coupler fitting to keep it from spreading open or moving around. Then use a wood block on top of the coupler fitting and hammer it onto the crank pulley as shown:
All done!
This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
Wear Sleeve Installer
-
- 10+ Years
- Posts: 103
- Joined: Mon Nov 12, 2012 9:52 pm
- Zip Code: 76502
Wear Sleeve Installer
Last edited by Barnyard on Tue Mar 20, 2018 6:57 pm, edited 1 time in total.
Reason: Added Missing Images
Reason: Added Missing Images
-
- Similar Topics
- Replies
- Views
- Last post
-
-
How to gauge clutch wear Attachment(s)
by Bronccat » Thu Jun 03, 2021 11:54 pm » in Lo-Boy Series - 154, 184, 185 - 14
- 883
-
by BigBill
Sun Jul 18, 2021 11:53 pm
-
-
-
clutch and throwout bearing wear? Attachment(s)
by pett3227b » Fri Mar 18, 2022 8:08 am » in Farmall Cub - 1
- 334
-
by Glen
Fri Mar 18, 2022 8:45 pm
-
-
- 0
- 137
-
by Scott 1234
Tue Nov 07, 2023 8:32 am
-
- 3
- 1407
-
by radioguy41
Thu Oct 06, 2022 5:37 pm
-
-
New cylinder sleeve, bore after install? Attachment(s)
by Countrytour » Thu Dec 22, 2022 12:55 pm » in Farmall C, Super C, 200 & 230 - 4
- 1198
-
by SamsFarm
Thu Dec 22, 2022 10:29 pm
-
Return to “Engine, Clutch, Transmission and Hydraulics”
Who is online
Users browsing this forum: No registered users and 0 guests