Farmall C & Super C Tractors, 1948-1954
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds
or one of our site sponsors for your tractor and parts needs.
Mon Aug 25, 2008 3:31 pm
This question was asked on another forum I am a member of, and so far no one has an answer. Is the wide front end on a "C"/Super "C" and a 240 the same, and will they swap out??
Mon Aug 25, 2008 5:21 pm
The answer is "no" and "maybe".
The wide front for the C through 230 are the same, or close enough for all practical purposes. It has a wish-bone support that is integral with the axle center section and pivots on the same pin as the axle. The 240 wish bone is a separate part and pivots in a ball socket under the bell housing. A 240 axle wouldn't be good on the earlier tractors. The bolster is a different part number on the 240 than the other models as well, so I don't know if the earlier axle will work on a 240 or not.
This is all relative to the Farmall 240. A 240 Utility is another beast completely.
Mon Aug 25, 2008 6:57 pm
Thanks Jim, I passed your reply on to the original question poster.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.