Cub 154 Will Not Move - Need Help with this, video attached

[AL Farmall Boy]

Here is the problem I found. Still need to get it apart to see what caused it and what all needs replacement. Watch the video…..

https://youtu.be/4yIULVfASWY

[Duner]

You are gaining. That must have made quite the racket before fail.

[Eugene]

The owner told me he replaced the clutch 2 years ago.

Do you own the tractor or is it owned by someone else?

I'm thinking the parts cost will be close to the purchase price of a working tractor. Purchase a parts tractor?

[AL Farmall Boy]

The owner told me he replaced the clutch 2 years ago.

Do you own the tractor or is it owned by someone else?

I'm thinking the parts cost will be close to the purchase price of a working tractor. Purchase a parts tractor?

Belongs to an older man and he just had the motor rebuilt. He wants it fixed

[Duner]

All Farmall Boy, take a look at this picture carefully. Do you see the differences between new and your old flywheel\?

[AL Farmall Boy]

All Farmall Boy, take a look at this picture carefully. Do you see the differences between new and your old flywheel\?

Haven't gotten the flywheel out yet. What are the differences?

[Duner]

Look at your hub where it attached to shaft into trans. Quite different I think but I can't tell from your video for certain. Sorry. Your flywheel hub should look like the one I posted.

[Jim Becker]

Looks to me like the whole portion of AL's hub that bolts to the shaft is broken off. Maybe the shaft is okay.

[AL Farmall Boy]

Looks to me like the whole portion of AL's hub that bolts to the shaft is broken off. Maybe the shaft is okay.

I HOPE the transmission short shaft is ok. Whole different ballgame if not. I should have the components out today after lunch. With a full time job and (2) kids under 4 at home, I'm only able to work on it during my 30 min lunch break or for about 20 min after work. Got to remove the front driveshaft bolt at engine hub and then drive wedges in to move engine forward. Hopefully everything will move easy like it should and it come out without much fuss.

[AL Farmall Boy]

Looks to me like the whole portion of AL's hub that bolts to the shaft is broken off. Maybe the shaft is okay.

You got it Jim! Here is a video showing what all I found. Now, I can't seem to find parts breakdown on the clutch system in the online CNH catalog.....

https://youtu.be/CmJMD8rVoJ4

[Jim Becker]

Were the broken pieces of the hub still in there or did they fly off to somewhere?

[Eugene]

I can't seem to find parts breakdown on the clutch system in the online CNH catalog.

Upper left, Quick links, IH Low Boy Series, Parts Manual.

[AL Farmall Boy]

I can't seem to find parts breakdown on the clutch system in the online CNH catalog.

Upper left, Quick links, IH Low Boy Series, Parts Manual.

I'm looking at that one now. I had it pulled up online a couple days ago but oddly its not there now.

[Eugene]

I'm looking at that one now. I had it pulled up online a couple days ago but oddly its not there now.

i just pulled it up and opened it to the clutch section.

Look under 154, then parts manual.

[AL Farmall Boy]

I'm looking at that one now. I had it pulled up online a couple days ago but oddly its not there now.

i just pulled it up and opened it to the clutch section.

Look under 154, then parts manual.

I’m mainly looking for the hardware pieces for the hub/coupler at the rear of engine. It isn’t shown in the parts manual. Rubber grommets, bolts, and washers. That and if there is a pilot bushing in the rear of crankshaft. The rest I can get from Hamilton Bobs.