1) Position the engine at TDC (any cylinder). Do this by slowly turning the engine until the notch in the front pulley is in line with the timing pointer. If there are 2 notches, use the second one.
3) Unhook all wires from the distributor, noting where each was. If the cap isn't being changed, it can be removed from the distributor and left with all wires in place, just remove the wire from the coil.
2) Remove distributor cap and note which way the rotor is pointing. Make your notes on a piece of paper, not on the distributor. Pencil lines in particular will make carbon tracks that will cause trouble.
3) Remove the entire distributor assembly (all of this in one piece).
4) Do whatever needs to be done to the distributor, new points, condenser, lubricate, set pont gap. Do not remove the distributor from the drive housing.
5) Rotate the distributor drive until the rotor points to the same position it did at step 3, and reinstall it.
6) Hook all the wires back up as they were at step 2.
7) Check the timing (which probably will be OK as it is).
This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
How To Remove/Replace A Distributor Without Losing Timing
-
- Team Cub
- Posts: 17279
- Joined: Sun Feb 02, 2003 2:59 pm
- Zip Code: 55319
- Circle of Safety: Y
- Location: MN
-
- Similar Topics
- Replies
- Views
- Last post
-
-
Welch plug...to replace or not replace...? Attachment(s)
by Dale Finch » Sun Sep 19, 2021 9:47 pm » in Farmall Cub - 7
- 478
-
by Dale Finch
Thu Sep 23, 2021 11:30 pm
-
-
-
Losing power when using plow with hydraulic lift
by Julien » Thu Sep 08, 2022 11:22 pm » in Farmall Cub - 14
- 505
-
by Don McCombs
Mon Sep 19, 2022 6:45 am
-
-
- 2
- 95
-
by Don McCombs
Tue Apr 09, 2024 9:58 am
-
- 3
- 264
-
by inairam
Thu Jul 22, 2021 2:20 pm
-
-
frame to replace engine in tractor Attachment(s)
by inairam » Wed Jan 19, 2022 1:09 pm » in Farmall Cub - 13
- 586
-
by Dale Finch
Thu Jan 20, 2022 5:52 pm
-
Return to “Ignition/Electrical”
Who is online
Users browsing this forum: No registered users and 0 guests