140 problems

Sat Feb 21, 2009 8:57 pm

My brother and I recently restored a beat up 140 for my dad. we fixed the sheetmetal and a friend that s a great mechanic rebuilt the trans mission. It ran great before wer restored it but now after we had the carb rebuilt it will run a second on ether eventually pick up gas and run for a second and cut off. Dad had the carb redone as the breather hose was off when painted and it got a shot of paint by accident. Mr. Olen put in a complete IH sold kit into it. We ran it for 2 days around the yard and it sat a few days i nthe carport and does its little trick. Its got a new gasket to. It acts like its just not getting enough gas. The sediment bowl is clean and the clear inline filters is clear to. Any suggestions.

Re: 140 problems

Sat Feb 21, 2009 11:38 pm

Check for fuel flow to and through the carb. If ok then remove, disassemble and dip the carb in carb cleaner. My guess is the carb is plugged up from the paint or a bit of debris.

Re: 140 problems

Sun Feb 22, 2009 6:20 pm

Thanks Eugene It has flow down to the carb, How would I test for flow through the carb? Im not a very good gas motoer person, still learning Mostly what I work on is Diesel on the machinery I operate at work.

Re: 140 problems

Sun Feb 22, 2009 6:33 pm

Did you say in line filter I know thats no good for a cub, is the 140 supposed to have one? I am not sure but check it out.

Re: 140 problems

Sun Feb 22, 2009 6:42 pm

It did not come with an in line filter. But with a new filter it want hurt untill it gets stopped up a bit. Which is the job of the filter :D
Just my nickel's worth

David

Re: 140 problems

Mon Mar 02, 2009 2:30 pm

In-Line Filter!!!! Yikes!

Lose the inline filter. Sounds like the engine needs gas.