How to install Vertical Exhaust

Time saving tips to keep your Cub running smooth

Moderators: Barnyard, Team Cub

How to install Vertical Exhaust

Postby John(videodoc) » Sun Mar 22, 2009 2:58 pm

1. Ensure that you have at least 6 inches of exhaust pipe surpassing the hood.
Image

2. If your pipe is too short you are likely to burn or bubble the paint as seen here
Image

3. If you rebuilt the engine or had fluids above the cylinders be sure you run the motor long enough to dry out the top end of the engine to prevent burning, fading and otherwise discoloring of the new decals that you put on your freshly painted hood.
Image

3. Make sure the muffler clamp, is clamped away from the hood (turned out). Shown incorrectly installed here
Image
Correctly installed here
Image

4. If you clamp the muffler over the hood and have a short pipe, you will bubble your new paint. As seen here in this picture. It may be hard to see a 3 dimension object in the picture, but trust me there is bubbles there. They are located where i cleaned the hood with my fingers to the right after i moved the clamp to the outside.
Image

5.I hope my mistakes in learning, will prevent you problems with your project.

John
User avatar
John(videodoc)
501 Club
501 Club
 
Posts: 6432
Joined: Mon Jul 25, 2005 10:16 pm
Location: IL, Paris just off of Interstate 70
Zip Code: 61944
Tractors Owned: -
55 F-Cub - snow plow and chains
4 Demonstrators Restored.
"Bette" - 22 mower
"Roxie" - 144 Complete Cults'
"Louise"(Done) IH 1000 One arm Loader
"Sandy"(Done) 193 Plow

1950 Demo "Billie" -(Woods 59")
Corn Stalk Cutter
23a Disc
Mid Mount Grader Blade
&
2005 Mahindra w/FEL
Circle of Safety Award
Circle of Safety: Y

Return to Engine, Clutch, Transmission and Hydraulics

Who is online

Users browsing this forum: No registered users and 0 guests