I put the 14 hp Kohler in the 109. I had to removed the balancer gears as the bottom gear was broken. After I put the engine back together it is smoking now. It did not smoke prior to taking the engine apart to remove the gears. Here is a sequence of what I did. I took the oil pan off, took the rod cap off, pushed the piston up to the top of the cylinder (I did not take the piston out of the block), slide the crankshaft over far enough to get the top balancer gear out, and then put everything back together. The engine runs good still with no knocks, but it is smoking now. No bad, but it was not smoke before the work. One other thing I did was to put new gaskets on the breather. I am wondering if the reed valve may have gotten out of place a little and now the oil is being drawn into the engine from this area. Is this possible or should I look in another direction?
Any help will be appreciated.
This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
Smoking Now
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
-
- 10+ Years
- Posts: 2182
- Joined: Sun Apr 08, 2007 9:36 am
- Zip Code: 38482
- Tractors Owned: 1949 Cub-Buttercub
582 Cub Cadet-Brutus
109 Cub Cadet-Bee-atrice
129 Cub Cadet-Artie - Location: TN, Santa Fe (South of Nashville)
Smoking Now
JimT
If you can't find it, don't lose it.
If you can't find it, don't lose it.
-
- 10+ Years
- Posts: 2338
- Joined: Sat Apr 10, 2004 6:12 pm
- Zip Code: 40218
- Circle of Safety: Y
- Location: KY, Louisville
Re: Smoking Now
I would check to ensure the reed valve is installed correctly and also ensure the small drain hole in the plate the reed fits against is at the bottom. I allows any oil to drain back into the crankcase and it is easy to install it upside down.
-
- 10+ Years
- Posts: 2182
- Joined: Sun Apr 08, 2007 9:36 am
- Zip Code: 38482
- Tractors Owned: 1949 Cub-Buttercub
582 Cub Cadet-Brutus
109 Cub Cadet-Bee-atrice
129 Cub Cadet-Artie - Location: TN, Santa Fe (South of Nashville)
Re: Smoking Now
Thanks Paul. When work gets out of the way I will pull the breather cover and check it out.
JimT
If you can't find it, don't lose it.
If you can't find it, don't lose it.
Who is online
Users browsing this forum: No registered users and 1 guest