This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
What is needed at Stonethrow
Forum rules
ALL CubFest discussion posted in other forums will be moved to this forum without advance notice.
IMPORTANT NOTE: CubFest organizers -- Notify a TeamCub member or the ADMIN (Dennis) to "Sticky" your event announcement in this forum.
ALL CubFest discussion posted in other forums will be moved to this forum without advance notice.
IMPORTANT NOTE: CubFest organizers -- Notify a TeamCub member or the ADMIN (Dennis) to "Sticky" your event announcement in this forum.
-
- Team Cub
- Posts: 24273
- Joined: Tue Aug 07, 2007 3:39 pm
- Zip Code: 45030
- Tractors Owned: At This Time
40 Farmall Cubs (Round Hood)
2 Farmall Cub (Square Hood)
2 IH Cubs (Square Hood)
5 Lo-Boys (Round Hood)
2 Lo-Boys (Square Hood)
2 Farmall 404's
1 Farmall H
1 Ferguson 20
1 Cub Cadet 125
1 Kubota B-7100 - Circle of Safety: Y
- Location: OH, New Haven (Hamilton County)
What is needed at Stonethrow
I just got off the phone with Kodiak. We kicked around thoughts on what special tools anyone may need to work on their Cub at Stonethrow. I will be bringing my radiator pressure tester with the bottom tray to bolt to the radiator. I will also have the Johnson Sickle Servicer for anyone needing to replace the knives on their sickle bar.
If anyone has, or needs, any special tools, let us know and if someone has what is needed they will know to bring it along. Three days and counting,see you there.
If anyone has, or needs, any special tools, let us know and if someone has what is needed they will know to bring it along. Three days and counting,see you there.
There are two ways to get enough Cubs. One is to continue to accumulate more and more. The other is to desire less.
-
- Cub Pro
- Posts: 3421
- Joined: Fri Sep 24, 2004 9:02 pm
- Zip Code: 30543
- Tractors Owned: 1948 Cub
- Circle of Safety: Y
- Location: Ga. Gillsville
Re: What is needed at Stonethrow
I have at the shop...... splitting stands, clutch alignment tool, front end alignment tool, compression guages, gas tank lip tool, front pulley puller, digital multimeters, timing light, and a very good selection of hammers if I do say so
Ron
Ron
I bought an old tractor all dusty and worn,
knew nothing about her just the year she was born
I washed her and greased her and painted her red
Now she lives happily right here in my shed.
HOME of THE STONETHROW CUBFEST
2007 Cub Tug Champion
knew nothing about her just the year she was born
I washed her and greased her and painted her red
Now she lives happily right here in my shed.
HOME of THE STONETHROW CUBFEST
2007 Cub Tug Champion
-
- 10+ Years
- Posts: 1629
- Joined: Mon Jan 29, 2007 7:09 pm
- Zip Code: 30114
- Tractors Owned: 1951 cub "Ms. Scarlett"
1962 Leora's loboy "Starburst" - Circle of Safety: Y
- Location: GA, Canton/Waleska
Re: What is needed at Stonethrow
does anyone have a tool to clean out the lower block/water inlet area?
-
- Team Cub
- Posts: 24273
- Joined: Tue Aug 07, 2007 3:39 pm
- Zip Code: 45030
- Tractors Owned: At This Time
40 Farmall Cubs (Round Hood)
2 Farmall Cub (Square Hood)
2 IH Cubs (Square Hood)
5 Lo-Boys (Round Hood)
2 Lo-Boys (Square Hood)
2 Farmall 404's
1 Farmall H
1 Ferguson 20
1 Cub Cadet 125
1 Kubota B-7100 - Circle of Safety: Y
- Location: OH, New Haven (Hamilton County)
Re: What is needed at Stonethrow
phildidit wrote:does anyone have a tool to clean out the lower block/water inlet area?
Phil, they are pretty easy to make. I just haven't gotten around to making mine yet. http://www.farmallcub.com/phpBB2/viewtopic.php?f=11&t=18457&p=134975&hilit=block#p134975
There are two ways to get enough Cubs. One is to continue to accumulate more and more. The other is to desire less.
-
- Cub Pro
- Posts: 5762
- Joined: Mon Jul 30, 2007 11:48 am
- Zip Code: 32460
- eBay ID: noles1432460
- Circle of Safety: Y
- Location: FL, Sneads
Re: What is needed at Stonethrow
phildidit wrote:does anyone have a tool to clean out the lower block/water inlet area?
I have one Phil. I will bring it along.
[ Post made via BlackBerry ]
In the middle of every difficulty lies opportunity. - Albert Einstein
.
Roy Edenfield
Deep South CubFest #10
February 14 & 15, 2020
.
Roy Edenfield
Deep South CubFest #10
February 14 & 15, 2020
-
- 10+ Years
- Posts: 1414
- Joined: Sun Aug 02, 2009 11:52 am
- Zip Code: 31648
- Tractors Owned: 1949 farmall cub (tinkerbell) 1949 allis chalmers(ole bess) 1949-50 ?john deere model a
- Location: statenville ga
Re: What is needed at Stonethrow
Mr E wrote:phildidit wrote:does anyone have a tool to clean out the lower block/water inlet area?
I have one Phil. I will bring it along.
[ Post made via BlackBerry ]
are ya bringing pnuts too?
He that tilleth his land shall be satisfied with bread: Proverbs 12:11
-
- Team Cub
- Posts: 11865
- Joined: Tue May 25, 2004 8:02 pm
- Zip Code: 80501
- Tractors Owned: Cubs, MH Pony, Shaw, Allis G, 1934 Silver King, JD LA and LI, Gibson D, David Bradley Tri-Trac
- Circle of Safety: Y
- Location: CO, Longmont
Re: What is needed at Stonethrow
Bob
"We don't need to think more,
we need to think differently."
-Albert Einstein
we need to think differently."
-Albert Einstein
-
- 10+ Years
- Posts: 2453
- Joined: Thu Mar 08, 2007 12:57 pm
- Zip Code: 30607
- Tractors Owned: Just One:
1957 Farmall Cub
"Corky"s Cub" - Location: Georgia, Jackson County
Re: What is needed at Stonethrow
Mr E wrote:phildidit wrote:does anyone have a tool to clean out the lower block/water inlet area?
I have one Phil. I will bring it along.
[ Post made via BlackBerry ]
Phil, if you want I can also bring my pressure washer--that's what I used on mine and it did a nifty job. Roy, what are you bringing?
Corky
I found this old Cub, Forgotten and Forlorn,
With pistons and valves frozen and worn.
Help from my buddies on Farmallcub.com,
And an engine from Ralph, (37’s the one),
Now ole Corky is running and back to life,
Much to the surprise of my dear, dear wife!
With pistons and valves frozen and worn.
Help from my buddies on Farmallcub.com,
And an engine from Ralph, (37’s the one),
Now ole Corky is running and back to life,
Much to the surprise of my dear, dear wife!
-
- Cub Pro
- Posts: 5762
- Joined: Mon Jul 30, 2007 11:48 am
- Zip Code: 32460
- eBay ID: noles1432460
- Circle of Safety: Y
- Location: FL, Sneads
Re: What is needed at Stonethrow
The little fitting (home made high pressure nozzle) to fit on end of hose.
Like the one in the link on Barnyard's post above.
Like the one in the link on Barnyard's post above.
In the middle of every difficulty lies opportunity. - Albert Einstein
.
Roy Edenfield
Deep South CubFest #10
February 14 & 15, 2020
.
Roy Edenfield
Deep South CubFest #10
February 14 & 15, 2020
-
- Team Cub
- Posts: 24273
- Joined: Tue Aug 07, 2007 3:39 pm
- Zip Code: 45030
- Tractors Owned: At This Time
40 Farmall Cubs (Round Hood)
2 Farmall Cub (Square Hood)
2 IH Cubs (Square Hood)
5 Lo-Boys (Round Hood)
2 Lo-Boys (Square Hood)
2 Farmall 404's
1 Farmall H
1 Ferguson 20
1 Cub Cadet 125
1 Kubota B-7100 - Circle of Safety: Y
- Location: OH, New Haven (Hamilton County)
Re: What is needed at Stonethrow
Corky's Cub wrote:Roy, what are you bringing?
Charles, Roy is bringing something similar to this.
Photo from "How To" forum by Eugene
There are two ways to get enough Cubs. One is to continue to accumulate more and more. The other is to desire less.
-
- 10+ Years
- Posts: 2453
- Joined: Thu Mar 08, 2007 12:57 pm
- Zip Code: 30607
- Tractors Owned: Just One:
1957 Farmall Cub
"Corky"s Cub" - Location: Georgia, Jackson County
Re: What is needed at Stonethrow
I saw that thread when it came out...Roy, how'd it do for you? When I cleaned mine out, I had the luxury of having the bolster off the tractor, because I was replacing a cracked one. The pressure washer did a great job...so good that in some places I had to repaint the inside with paint to seal the cast iron. But I think that was because I also let it spend the night in Corky's rust annhilator--e-tank.
I have a pistol-grip sprayer on the pressure washer that has no extension, so it can get in the nooks and crannies pretty good. But if other/better experience says we won't need that for Phil, I'll leave it at home.
I have a pistol-grip sprayer on the pressure washer that has no extension, so it can get in the nooks and crannies pretty good. But if other/better experience says we won't need that for Phil, I'll leave it at home.
Barnyard wrote:Corky's Cub wrote:Roy, what are you bringing?
Charles, Roy is bringing something similar to this.
Photo from "How To" forum by Eugene
I found this old Cub, Forgotten and Forlorn,
With pistons and valves frozen and worn.
Help from my buddies on Farmallcub.com,
And an engine from Ralph, (37’s the one),
Now ole Corky is running and back to life,
Much to the surprise of my dear, dear wife!
With pistons and valves frozen and worn.
Help from my buddies on Farmallcub.com,
And an engine from Ralph, (37’s the one),
Now ole Corky is running and back to life,
Much to the surprise of my dear, dear wife!
-
- Cub Pro
- Posts: 5762
- Joined: Mon Jul 30, 2007 11:48 am
- Zip Code: 32460
- eBay ID: noles1432460
- Circle of Safety: Y
- Location: FL, Sneads
Re: What is needed at Stonethrow
Bring it own! The little contraption works good if you don't have a pressure washer, but it doesn't compete with your rig.
In the middle of every difficulty lies opportunity. - Albert Einstein
.
Roy Edenfield
Deep South CubFest #10
February 14 & 15, 2020
.
Roy Edenfield
Deep South CubFest #10
February 14 & 15, 2020
-
- 10+ Years
Re: What is needed at Stonethrow
Mine is a bit longer and will go up into the block, and into the bloster too for those hard to reach places.
Return to “CubFest and Tractor Show Announcements & Discussions”
Who is online
Users browsing this forum: No registered users and 1 guest