Recently while mowing my pto quit. I have had the problem that when mowing for a while and
I stall the mower I would have to let things cool down for about an hour before the pto would work again
but like I said it just quit on its own this time. I took the pto switch off and cleaned the terminals and checked the
fuse. Everything seems OK. I found a hit on this site "184 pto switch" and it seems to bee the same. Any additional
thoughts. If it could be a switch where can I get one?
This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
184 pto quit
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
-
- 10+ Years
- Posts: 188
- Joined: Wed Sep 03, 2008 4:35 pm
- Zip Code: 07869
- Location: Randolph, NJ
Re: 184 pto quit
glmassar, the 184 PTO switch is #107372C1 which also subs to #725-3022 (the same switch, but used on many cub cadets of that era). The #725-3022 can be Googled and found in many places for about $20 plus shipping. I would clean and check all of the electrical connections; fuse, switch, connections at PTO, and grounds. Then I would replace the switch since it is relatively inexpensive and most likely subject 'contact wear' over the years.
However, the 'heating up' over an hours use and then quitting until it 'cools off' sounds most likely like the 'coil windings' in the electric magnetic part of the PTO clutch unit itself. If this is indeed the problem, then contact 'Hamilton Bob' for a used coil. They are a rather pricey item.
Good Luck, NJDale
However, the 'heating up' over an hours use and then quitting until it 'cools off' sounds most likely like the 'coil windings' in the electric magnetic part of the PTO clutch unit itself. If this is indeed the problem, then contact 'Hamilton Bob' for a used coil. They are a rather pricey item.
Good Luck, NJDale
-
- 10+ Years
- Posts: 2791
- Joined: Tue Jul 22, 2008 12:44 pm
- Zip Code: 48370
- Tractors Owned: 184
- Location: Oxford, MI
Re: 184 pto quit
Do clean all of the connections before buying parts. Also, clean inside the fuse holder on the dash. It may have rusted inside.
184 w/ Creeper & 3-Point
IH 3160a Mower
IH Model 15 Tiller
IH-54 Blade
IH 3160a Mower
IH Model 15 Tiller
IH-54 Blade
-
- 10+ Years
- Posts: 2680
- Joined: Mon Oct 24, 2005 11:35 am
- Zip Code: 14072
- eBay ID: toysforjake
- Tractors Owned: Lots of Cub Cadets!
1951 Farmall Cub
1977 IH Cub
1966 IH Cub
1965 IH Lo Boy
1964 IH Lo Boy
1949 Farmall Cub
Several IH 154 Lo Boys
1979 IH 184 Lo Boy
Simplicity 4416 Sovereign
Simplicity Conquest
Simplicity Legacy 4x4 Diesel
Mitsubishi MT180D 4x4 Diesel - Circle of Safety: Y
- Location: Grand Island, NY
Re: 184 pto quit
Also, if the PTO clutch is out of adjustment, it will heat up too much and cut out. This is a common problem on Cub Cadets with electric PTO clutches. Unfortunately, on the 184, it's not real easy to get to.
Cub Cadets 682, 1811, 1864, Simplicity Legacy XL 4x4 Diesel with FEL, 60" mower, 50" Tiller
-
- 10+ Years
- Posts: 6
- Joined: Fri May 04, 2012 8:16 am
- Zip Code: 45742
Re: 184 pto quit
Thanks all for your help. One additional question. What should be the voltage at the pto switch and at the connector that goes into the clutch down below the pto switch. This is where the shaft connects into. I have been getting readings anywhere from .15 up to .30
George
George
-
- 10+ Years
- Posts: 134
- Joined: Tue Aug 03, 2010 11:34 am
- Zip Code: 46975
Re: 184 pto quit
IIRC . . . what your doing/seeing is called a voltage drop test. In essence, if 14.8 volts is available at the battery, somewhere around 14.5-14.6 is going to the clutch, (that's good). The .1-.3 is being used up by the switch.
Return to “Lo-Boy Series - 154, 184, 185”
Who is online
Users browsing this forum: SONNY and 3 guests